The function of a constant temperature faucet is to stabilize the outlet water temperature, which can handle the instability of showers, heating, etc. It is increasingly used in households.

Repair method for constant temperature faucet:

1. The outlet water of the constant temperature faucet is maintained at a temperature. Assuming that the outlet water is uneven and the temperature varies, it is necessary to check whether the outlet water is continuous or intermittent. Assuming it is continuous, it is caused by excessive pressure on one side. It is possible to reduce the pressure of cold water or hot water appropriately, and reduce the pressure on which side is higher. Assuming it is intermittent, it may be due to the setting of the water temperature being too high. It is necessary to adjust the water temperature to a suitable temperature, about 34 ℃ -36 ℃, which can meet the demand without being too high. Assuming neither of the above conditions is true, it is that there is a problem with the constant temperature valve core and replacement is required.

2. If the water coming out of the thermostatic faucet is not hot, the first thing to check is whether the water inlet is blocked or if there is residual cold water in the hot water pipeline. Clean the filter net and drain the cold water in the hot water pipeline to treat it.

Check the temperature of the hot water. If the temperature of the incoming hot water reaches 55 ℃ or above, assuming it is a bungalow or rooftop household, check if the hot water pressure is too low. Thirdly, check if the cold and hot water in the inlet pipe are connected incorrectly, resulting in only one type of water being produced.

3. Assuming a gas water heater is used, if the fire is unstable during operation, it will lead to insufficient flow and temperature of hot water. It is necessary to adjust the water heater to high fire and high flow rate.

4. Assuming an electric water heater is used, if the outlet water temperature is too low, it is because the set temperature of the electric water heater is generally around 50 ℃. The water at this temperature will become lower after passing through the constant temperature faucet. It is necessary to set the temperature of the electric water heater higher to ensure that the outlet water from the constant temperature faucet will not be too low.

5. If there are foreign objects blocking the hot and cold water phase, use a screwdriver to push it and then drain the water to handle it. If it cannot be handled smoothly, a new check valve needs to be replaced.

If there is water leakage at the interface of the constant temperature faucet, it is possible to tighten it with something or wrap a raw material tape around the thread.

Article source: Kaiping Bathroom Faucet http://www.clasito.net/