Strict requirements should be placed on the height of the faucet, and attention should be paid to issues such as water leakage during installation Therefore, when installing a bathroom faucet, the convention of the owner&# 039; S use should be taken into consideration What is the general height of the bathroom faucet and where is the height orientation of the bathroom faucet?

Device for single hole faucet

1. Device for single hole base faucet

When purchasing a single side base faucet, you should pay attention to the diameter of the water outlet Currently, most of the faucets on the market are hard pipes for water inlet, so you should pay attention to serving the height of the water outlet It is suitable to move 35 minutes down wards from the basin When installing, the supporting role valve should be selected, and the angle valve should be fixed with the cold and hot water pipes of the wall outlet When you notice a gap between the angle valve and the faucet water pipe, go buy an extension pipe to connect it

Remember, do not use other water pipes to connect, because if the water pressure is high, it is easy to fall off and leak, causing losses to you If the inlet pipe is too long and exceeds the outlet pipe, you can cut off a part according to your needs If the viewpoint is not suitable, you can modelly bend to the direction you need according to your needs Remember: Do not bend hard to 90 degrees or greater When installing the basin to drain water, please do not forget to purchase the small connector of the faucet (faucet short circuit) Please don&# 039; T forget to flush the water pipes burnt in the wall in advance before you install them

2. The device of the thermodynamic faucet

Before starting the thermal faucet, please check if the water pipe is hot on the left and cold on the right Remember not to connect the hot and cold water pipes incorrectly to avoid the faucet not working properly Gas and solar energy cannot use thermodynamic faucets because the water pressure is too low Please do not forget to install a cold and hot water filter screen for the thermodynamic faucet

3. Shower and faucet (wall mounted) devices

After purchasing a shower, bath tub, or wall mounted faucet, you can choose the appropriate height for burying the water pipe The distance between the hot and cold water pipes should reach 15 centers Don&# 039; T forget to flush the water pipe before installation to avoid water quality being too hard and causing damage to the faucet Concealed shower and bathtub faucet: After purchasing a Concealed faucet, the valve core of the faucet should generally be embedded in the wall Pay attention to the thickness of the bathroom wall before embedding If the wall is too thin, the valve core will not be embedded Do not easily remove the plastic protective cover of the valve core during pre embedding to avoid damage to the valve core caused by cement and other miscellaneous tasks In addition, when embedding the valve core, attention should also be paid to the up and down, left and right directions of the valve core to avoid incorrect embedding There is a deviation in the size of the embedded water inlet pipe of the wall mounted faucet, and a suitable adjustment knob can be used for positioning

Article source: Kaiping Bathroom Faucet http://www.clasito.net/