Due to the imbalance of the store, it is difficult for consumers to choose lead-free faucet products. In this regard, we can use some cleaning and protection tricks in our usual use to reduce the damage caused by lead overload. The following is the introduction of the traditional protection and reduction of lead damage for faucets by the fine craftsman board editor. We hope it can be helpful to you.

1、 Knowledge in receiving water ensures healthy drinking water

Experts suggest that when turning on the faucet every morning, you can first empty it for a while, then fill it with water and use it to flush the bathroom, mop the floor, etc. Because when the faucet is just turned on, the water usually contains more harmful substances, such as releasing more lead. Similarly, a faucet that has not been opened for a long time cannot be immediately connected to water for drinking.

2、 The longer the time, the more lead will be separated and replaced on time

Replace the faucet on time. Nowadays, chlorine is often used as a disinfectant in tap water, and the remaining chloride compounds in the water will exacerbate the separation of lead elements from the faucet. Generally speaking, if copper alloy faucets are used for more than 5 years, the amount of lead released will greatly increase. Therefore, it is recommended that the faucet in residents' homes should not be used for too long.

3、 Diligent in cleaning up impurities in the sieve

If after a period of use, it is found that the water output decreases and even shows the appearance of the water heater stalling, it may be due to water and sand blocking the screen. At this moment, quietly unscrew the sieve cover at the outlet of the faucet to remove impurities. Generally speaking, cleaning the impurities on time, once every three months, is very good for water quality and the health of family members.

4、 Cleaning the protective outer coating of the faucet

To protect the coating of the faucet, a soft cotton cloth that has been wrung out should be used for cleaning. Do not use a damp towel to directly wipe it to avoid leaving scale, and do not use items with burrs to wipe and damage the coating. To avoid letting the faucet come into contact with acidic or alkaline liquids, you can spray a neutral cleaning agent on a soft cloth and quietly wipe the faucet.

5、 Avoid aging of coating and use protein safely

Gold-plated products may experience slight drop and loss of luster when gilded, but protein can be used to maintain the gloss of the coating. Beat the protein with an egg beater until it slightly bubbles, then clean the faucet with warm water and wipe it dry. Dip in a small amount of protein and quietly wipe it on the gold-plated surface to protect the gloss of the coating.

Article source; Kaiping faucet http://www.clasito.net