1、 The reason for water leakage

The reason for water leakage at the outlet is due to the wear of the axial gasket inside the faucet. Use pliers to loosen and remove the pressure cap bolt, then use a clamp to remove the shaft gasket and replace it with a new one.

2. The reason for the leakage in the lower gap of the faucet bolt is due to the wear of the triangular sealing gasket inside the pressure cover. Be able to loosen the screw and remove the bolt head, then loosen the cover and remove it. Then, take out the triangular seal on the inner side of the cover and replace it with a new one.

3. Leakage at the receiving joint: It is generally due to the loosening of the cap nut, which can be re tightened or replaced with a new U-shaped sealing gasket.

4. Water quality deterioration situation: It may be due to water leakage. Due to the water stop disk of the single gun faucet getting stuck with sand and gravel, it is still necessary to find a repairman to dismantle the faucet for cleaning. However, if the rubber pad is damaged, it must be replaced.

2、 Maintenance methods

1. First, tighten the faucet and use pliers to rotate it counterclockwise to remove it.

2. Turn the threaded hole outward and wrap it 5-6 times clockwise with wind imprinted tape in the threaded area.

3. Check if the faucet has been properly adjusted and secured with a water wrench in the clockwise direction. After the installation is completed, turn on the main switch and try to confirm if there is still water leakage.

The article originates from a faucet manufacturer: http://www.clasito.net/