1. The reason for the leakage of the faucet

1. Poor water quality can lead to the accumulation of waste inside the valve core, resulting in loose closures of the valve core and subsequence water leakage

During the use of the valve core, scratches may occur due to the wear and tear of external strong inclusions For example, when the water supply pipe irregularities and flows out from the beginning, the water may contain trust or sand particles, which can cause scratches on the surface of the valve core during the opening and closing process, making it impossible to seal and leakage It is particularly important to pay attention to cleaning the impurities inside the water pipe when installing the faucet

3. The connection between the water inlet host and the main body of the faucet in the pipeline is leaving due to improve installation

2. The reason why the faucet losses its cluster

1. The viewpoint that faucets do not require any maintenance to trust is incorrect Because even the best faucet has many small holes on its electroplating layer that cannot be distinguished by the taken eye The difference is: high quality products will have fewer small holes and smaller pore sizes; But if no maintenance is done, daily mixed gases and corrosive gases produced by frequently used hand sanitizers, oils, etc. will always run in from here Over time, the material under the electroplating layer will rust and see out to the surface

2. The method to keep the faucet bright and rust free: Regularly wire the faucet with wax every half a month or once a month to seal the small holes on the surface of the electroplating coating and prevent moisture and corrosive gases from entering Special reminder from the editor: Do not use hard objects such as steel wire balls to clean the faucet

3. The reasons for the intermittent heating and cooling of a constant temperature faucet

1. Because the relevant amount of hot water used in summer is relatively small, the water heater is very simple to meet, and once it is satisfied, the attraction will be stopped; When there is a shortage of hot water, burn it again; Repeated burning, extending, and burning in this way results in hot water supply being present, absent, and present, leading to intermittent cooling and heating of the impact Solution: Lower the fire and temperature of the water heater correlation

2. The power of the supporting water heater is insufficient, and the required heat cannot be met Solution: Replace the high power water heater

3. The filter screen is blocked by waste, causing a decrease in water pressure Solution: Clean the filter screen at the corner valve

Article source: Kaiping faucet http://www.clasito.net/