1. Preparation work

It is very important to prepare before dismantling the faucet, otherwise it may lead to the waste of water resources. Before dismantling, the water valve at home should be closed first. After tightening the water valve, you can find a basin to place under the water pipe to prevent water leakage in the house if the water pipe is not tightly closed.

2. Preliminary disassembly

After the preparation work is completed, there is usually some water left in the water pipe. Before dismantling, drain this water first. Usually, a wrench is used to separate the water pipe from the inlet pipe. Assuming it is the inlet pipe in the bathroom, the force needs to be well controlled to prevent damage to the water pipe due to excessive force. When parting ways, you can stabilize the water pipe with one hand and then roll the handle with the other hand. The process of removing it is generally relatively simple.

After the water pipes were separated, it was time to dismantle the faucet. Need to use a screwdriver to remove the screw on the faucet handle, and then remove the faucet handle. If the screw is embedded in the hole, you can use a flashlight to observe the screw first, and then select a suitable screwdriver.

3. Cut the interface with a saw

For some faucets with severe rusting, you can choose to use a saw to open them and cut off the unusable faucets. However, some faucets may not be easy to unscrew simply by using a screwdriver.

Article source: Kaiping faucet http://www.clasito.net